CADDX 8600UF98 Instrukcja Użytkownika Pobierz pdf (Strona 7)

KEYPAD CONTROL TONES (BEEPS)

A sounder is built into the keypad and may sound for any of the following reasons:

# Beeps for all keypresses.

# Sounds a continuous tone during the Entry delay time.

# Pulses when a "Day Zone" is violated, a zone configured for fire has a trouble condition,

or when the armed status changes and the "Power" light if off. It will also pulse when a

zone light designated as a fire zone is on steady from a previous alarm, or blinking as a

result of a previous fire trouble condition. When pulsing, it can be silenced by entering a

valid code. (The armed state of your security system will not change when a valid code is

entered to silence the pulsing sounder.)

# 3 Beeps for trying to arm when a faulted zone is not bypassed.

# Beeps 1 second for "CHIME" and when this feature is activated or deactivated.

# 3 Beeps when errors are made reprogramming codes.

# Beeps 1 second at the end of the exit delay.

RESETTING YOUR SECURITY CONTROL CENTER

In the event of a system malfunction in the Security Control Center, press the reset key [#]

located on the Keypad Control for one (1) second. This should reset the code sequence and

restore normal operation. If the problem persists, call the service number located on page 1

of this booklet for service.

TESTING YOUR SECURITY SYSTEM

There are several tests you should perform on a periodic basis (at least once a week) to insure

that your Security System is functioning properly.

# Enable the "CHIME" Feature and open all protected windows and doors. The Keypad

Control should sound (beep) for each device and the appropriate yellow zone light should

blink.

# Walk into all areas protected by motion detection devices while someone observes the

Keypad Control. The appropriate yellow zone light should blink for each sensor tested.

# If your system has a "FIRE" Zone, the Smoke or Heat detectors should be tested at least

monthly. If your Security System is monitored by a Central Monitoring Station, always call

before to let them know that you are about to conduct a test of the fire detection system.

Always call after the test to ask for results and to put your fire detection system back into

service.

# If the Siren/Bell test option has been selected by your installing company, you may activate

the siren/bell by pressing the one [1] and the seven [7] keys at the same time for one

second. To silence the siren/bell, enter your 4 digit Master or Auxiliary Code.

If any of the above tests are not successful or the results unclear, contact your service company

at the phone number listed on page 1 of this booklet.

1 2 3 4 5 6 7 8 9 10

Brak uwag

CADDX 8600UF98 Instrukcja Użytkownika Strona 7