CADDX NX-6 Instrukcja Instalacji Pobierz pdf (Strona 24)

GE Security

[*]-[6] ASSIGNING AUTHORITY LEVEL

Note: You must be authorized to access the partition that you wish to add to, or remove

from, another person’s authority.

1. Enter [*]-[6] The LCD screen will prompt for a code.

2. Enter [master code] The LCD screen will prompt for a user number.

Enter the 2 digit user number

(always 2 digits, i.e. “03” for

user 3)

The LCD screen will prompt for a new code. The

LCD will now prompt you for the first in the

following list of attributes.

PROMPTS

Outputs used?

Open / close report?

Bypass enable?

Arm / disarm?

If prompt 1 (“Outputs

used?”) is answered NO,

the LCD will display the

four messages below

If prompt 1 (“Outputs

used?”) is answered YES,

the LCD will display the

four messages below

Master code? Output 4 enable?

Sched. arm only? Output 3 enable?

Arm only? Output 2 enable?

Reserved Output 1 enable?

4 Enter a partition number.

The LCD screen will prompt you for the next user

code.

Note: The default allows access to all partitions. The first keypress will remove

access to the partition. To re-establish access, press the partition number again.

When completed, press [*].

5. If another user code needs to be programmed, return to step 3.

6. To exit this feature, press [#].

NOTE:

WHEN PROGRAMMING THE USER CODES FOR A PARTITIONED SYSTEM, LEAVE

AT LEAST ONE CODE WITH ACCESS TO ALL PARTITIONS. UNLESS YOU DO THIS,

YOU WILL NOT BE ABLE TO ADD NEW USERS. (THE CODE CAN BE THE “GO TO

PROGRAM CODE”, IF ENABLED IN LOCATION 43 OF THE NX-6 CONTROL PANEL).

IF YOU WANT TO LET THE END USER ADD NEW CODES, YOU MUST REMOVE

THE PARTITION AUTHORITY FROM ALL BLANK CODES.

NX-6-EUR Installation manual Page 24 23/12/04

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 103 104

Komentarze do niniejszej Instrukcji

Brak uwag

CADDX NX-6 Instrukcja Instalacji Strona 24

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa CADDX NX-6