CADDX NX-6 Instrukcja Instalacji Pobierz pdf (Strona 33)

GE Security

IMPORTANT REMARKS

Tamper memorization

If location 37 segment 6 option 8 is set, tamper alarm indications (zone tampers and box

tampers) can be erased by entering a valid user code.

If location 37 segment 6 option 8 is not set, tamper alarm indications (zone tampers and

box tampers) can only be erased by entering the program mode. In this case, tamper

alarm indications can only be reset by the installer.

Disabling tamper alarms in program mode

Tamper alarms (originating from zones and boxes) will be disabled during program mode.

This allows the installer to service the system without generating unwanted tamper

alarms. Note that the timeout for the program mode is 15 minutes.

Country code

The NX-6 has the ability to set different “country codes”. Each country code has specific

default settings. Before start programming the NX-6, it is important to select the country

code that is required. Once the country code has been selected, it will remain set, even

after an installer reset. When changing the country code during programming, all existing

programming will be cleared to the defaults for that country (see location 213).

Keypad tamper lockout

When this option is enabled (see location 23, segment 1), the NX-6 will disable the

keypad for 60 seconds, and will communicate a tamper signal to the central station if 30

key presses are entered without producing a valid code.

NX-6-EUR Installation manual Page 33 23/12/04

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 103 104

Brak uwag

CADDX NX-6 Instrukcja Instalacji Strona 33