CADDX NX-6 Instrukcja Instalacji Pobierz pdf (Strona 84)

GE Security

42 51 GO TO PROGRAM CODE 9-7-1-3-0-0

GO TO PROGRAM CODE PARTITION AND AUTHORIZATION

Segment 1 (Circle Numbers To Program)

1 Reserved

2 Enables “Go To Program Code” as an arm only code

3 Enables “Go To Program Code” as an arm only code after closing

4 Enables “Go To Program Code” as a master arm/disarm code (can change user codes)

5 Enables “Go To Program Code” as an arm/disarm code

6 Enables “Go To Program Code” to bypass zones

7 Enables “Go To Program Code” opening and closing reports

8 Reserved

Segment 2 (Circle Numbers To Program)

1 Enables “Go To Program Code” for partition #1.

2 Enables “Go To Program Code” for partition #2.

44 52 DURESS CODE 15-15-15-15-15-15

AUXILIARY OUTPUTS 1-4 PARTITION SELECTION

Segments 1 2 3 4

Partition 1 1 1 1 1

45 53

Partition 2 2 2 2 2

AUXILIARY OUTPUTS 1-4 SPECIAL TIMING

Segments 1 2 3 4

Auxiliary output timed in minutes 1 1 1 1

Auxiliary output to latch 2 2 2 2

Auxiliary output to stop timing when user code is entered 3 3 3 3

Auxiliary output to activate only between closing and opening time 4 4 4 4

Auxiliary output to activate only between opening and closing time 5 5 5 5

Invert auxiliary output (0 volts going to 12 volts when activated) 6 6 6 6

Reserved 7 7 7 7

46 53

Reserved 8 8 8 8

AUXILIARY OUTPUT 1, EVENT & TIME (open collector 1)

Segment 1 Program the event number for output 1 7=Each siren activation

47 54

Segment 2 Program the timing for output 1 0 sec.=follow event

AUXILIARY OUTPUT 2, EVENT & TIME (open collector 2)

Segment 1 Program the event number for output 2 7=Each siren activation

48 54

Segment 2 Program the timing for output 1 0 sec.=follow event

AUXILIARY OUTPUT 3, EVENT & TIME (open collector 3)

Segment 1 Program the event number for output 3 2=24 hour alarm

49 54

Segment 2 Program the timing for output 3 10=10 sec.

AUXILIARY OUTPUT 4, EVENT & TIME (open collector 4)

Segment 1 Program the event number for output 4 39= smoke power

50 54

Segment 2 Program the timing for output 4 0=follow event

AUTOTEST CONTROL

Segment 1 Program a “1” if the interval is hours, or a “0” for

days. Add a “2” to suppress the daily test or a “3” to

suppress the hourly test

Segment 2 Program the autotest interval from 1-255 days or

hours

Segment 3 Program the autotest report in 24 hour time format 2

51 56

Segment 4 Program the autotest report time, minutes after the

hour

NX-6-EUR Installation manual Page 84 23/12/04

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 103 104

Komentarze do niniejszej Instrukcji

Brak uwag

CADDX NX-6 Instrukcja Instalacji Strona 84

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa CADDX NX-6