CADDX NX-6 Instrukcja Instalacji Pobierz pdf (Strona 69)

GE Security

Segment 4

1 = On: enables zone activity monitor

2 =

On: enables end of line resistor defeat on non-fire/non-keyswitch

zones

3 =

On : enables zone to act as request to exit input / disables for

alarm activation

4 = On : enables zone to act as access entry point (Door Shunt) (…)

5 = Reserved

6 = Reserved

7 = Reserved

8 = Reserved

Segment 5

1-8 Reserved

Note :

…

Refer to NX-1701E card reader installer manual. Do not enable this segment

unless configured with Access Control.

LOCATION 112 - CONFIGURATION GROUP 2 ALARM EVENT CODE (1 segment, numerical data)

Location 112 contains the event code that is sent for a Contact ID or SIA report. The

desired event code should be chosen from the list on pages 121-122. The zone ID will be

the zone that is in alarm.

This location is not used for slow speed formats (like 4+2 and 3+1). This location may

also contain the alarm report code for the Robofon format (value 00-99).

LOCATION 113 - CONFIGURATION GROUP 2 CHARACTERISTIC SELECT (5 segments, feature

selection data)

Use the “Configuration Group Characteristic Selections” described in Location 111.

LOCATION 114 - CONFIGURATION GROUP 3 ALARM EVENT CODE (1 segment, numerical data)

Location 114 contains the event code that is sent for a Contact ID or SIA report. The

desired event code should be chosen from the list on pages 121-122. The zone ID will be

the zone that is in alarm.

This location is not used for slow speed formats (like 4+2 and 3+1). This location may

also contain the alarm report code for the Robofon format (value 00-99).

LOCATION 115 - CONFIGURATION GROUP 3 CHARACTERISTIC SELECT (5 segments, feature

selection data)

Use the “Configuration Group Characteristic Selections” described in Location 111.

LOCATION 116 - CONFIGURATION GROUP 4 ALARM EVENT CODE (1 segment, numerical data)

Location 116 contains the event code that is sent for a Contact ID or SIA report. The

desired event code should be chosen from the list on pages 121-122. The zone ID will be

the zone that is in alarm. This location is not used for slow speed formats (like 4+2 and

3+1). This location may also contain the alarm report code for the Robofon format (value

00-99).

NX-6-EUR Installation manual Page 69 23/12/04

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 103 104

Komentarze do niniejszej Instrukcji

Brak uwag

CADDX NX-6 Instrukcja Instalacji Strona 69

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa CADDX NX-6