CADDX NX-6 Instrukcja Instalacji Pobierz pdf (Strona 36)

GE Security

Reporting events to phone number 1

Phone N°1 has two programming locations that are used to select the events which are

reported to this phone number.

Location 4 is used to select which events are reported to phone N°1. Location 5 is used

to select which partitions are reported to phone N°1. If you do not want dual or split

reporting, use location 4 to select all events to phone N°1, and leave location 5 at the

factory default of “0”. If you want dual or split reporting, and the split is based on the event

type (such as alarm, open/close, etc.), you should use location 4 to select only those

events that should be reported to phone N°1, and you should leave location 5 at the

factory default of “0”. If you want dual or split reporting, and the split is based on partition,

you should program location 4 as a “0” and use location 5 to select those partitions that

are to be reported to phone N°1. If no events are to be reported to phone N°1, both

locations should be programmed as “0”.

LOCATION 4 - EVENTS REPORTED TO PHONE N° 1 (2 segments, feature selection data)

Segment 1

1 = Alarms

2 = Opening and closings

3 = Zone bypass and bypass restores

4 = Zone trouble and trouble restores

5 =

Power fail (AC failure), low battery, power restore (AC restore) ,

and low battery bestore

6 = Bell cut, bell cut restore, telephone line restore

7 = Test reports

8 = Start and end programming, download complete and log full

Segment 2

1 = Zone and box tamper

2 = Auxiliary power over-current, and restore

3 = Wireless sensor missing and restore

4 = Wireless sensor low battery and restore

5 =

Expander trouble and restore (keypads are considered as

expanders)

6 = Fail to communicate

7 = Alarm restore

8 = Tamper restore

NX-6-EUR Installation manual Page 36 23/12/04

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 103 104

Brak uwag

CADDX NX-6 Instrukcja Instalacji Strona 36